Crosslee G408RoyalBuckingham Bedienungsanleitung

0102 095 506217+(52<$/%8&.,1*+$0USERS INSTRUCTIONSTHIS CAT I2H APPLIANCE IS FOR USEON NATURAL GAS G20 AT A SUPPLYPRESSURE OF 20 mbar IN GB &a

The following relevant Codes of Practice and British Standards:The Building Regulations issued by the Department of the Environment.The Building Stand

Contents Check ListFire Box Assembly-c/w Burner Assembly Coal Pack Including;Lower Fibre Back 11 Medium Strata CoalsL& R Hand Side Cheeks 8 Small

Installation using a 5" Diameter Metal Flue Box.Important: The spigot restrictor marked B’ must be fitted See Fig. 4When the metal flue box is to

- 6 -

Installation of the ApplianceCheck that the chimney conforms to the required specifications as previously stated. Examine thecondition and carry out a

ImportantTHE RESTRICTOR PLATES MARKED ’A’ AND ’B MUST NOT BE USED WITH PRE-CASTFLUES.The restrictor marked A is for use with 7in. (175mm) diameter flu

Locate and screw the vent box to the spacer frame with two 8 x ¾ self-tapping screws at the top and twoM4 Taptite screws at the bottom, ensuring that

- 10 -

Laying the Coal BedPlace the L & R hand side cheeks with the rebated edges on the sides of the burner support frame andpush towards the back. Plac

- 12 -

DESCRIPTIONThis Royal Cozy Fires Decorative Fuel Effect gas fire has been developed to give a realistic coal burningappearance with the convenience of

Checking Operation of FineTurn on the gas supply at the meter and to the appliance at the isolating cock. Purge the air to theappliance. Rotate the co

Advise that the appliance be fitted with an Oxy-pilot to prevent continued operation in the event ofspillage occurring. If the fire shuts ’OFF’ repeat

IV) TO REPLACE THE OXY-PILOT ASSEMBLY: The assembly is not an item that can beserviced as part of its calibration depends on the proximity of the spar

Royal Cozyfires are manufactured by:CROSSLEE plcAber Park Industrial Estate,Aber Road, Flint, Flintshire. CH6 5EXSpares Tel 01422 203963Fax: 01422 204

Clearance to SideMinimum clearance required to any combustible material to the side of the appliance must be l50mm.Clearance to ShelvesMinimum clearan

Dismantling the Fire Bed for CleaningAllow the fire bed to cool for 1 hour before handling any components.Should any soot accumulation become excessiv

Coal Lay-outPosition 4 large coals with their rear edge located on the burner inserts and the front on the coal front - rotateslightly as shown in Fig

- 6 -Sectional View of firebed(without small coals laid)Place the eight small coalsrandomly and in a stableposition between the largecoals.

Cleaning the Front of the ApplianceThe fire must be turned off and allowed to cool. The paintwork should be cleaned with a soft cloth or soapy water.C

0102 095 506317+(52<$/%8&.,1*+$0INSTALLATION & SERVICING INSTRUCTIONSTHIS CAT I2H APPLIANCE IS FOR USEON NATURAL GAS G20 AT A SUPPLYPRESS

DESCRIPTIONThis Royal Cozy Fires Decorative Fuel Effect gas fire has been developed to give a realistic coal burningappearance with the convenience of