Crosslee CL847W-031284715901 Bedienungsanleitung PDF herunterladen

INSTRUCTIONS FOR USE

IMPORTANT:

PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE.

KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.

7. REVERSING THE DOOR OPENING

4213 094 84424

– This tumble dryer is intended for NORMAL DOMESTIC

USE ONLY.

– Please note it is not recommended that the dryer be

placed directly next to ovens or cookers, as the

performance of the dryer may be affected.

– Adequate ventilation must be provided to avoid back flow

of gases into the room from appliances burning other fuels,

including open fires.

– Do not stack the tumble dryer on top of other appliances

without the correct stacking kit.

–Any electrical work required to install the appliance should

be carried out by a qualified person.

–It is important to clean the lint filter after each drying cycle

or the restrictions to airflow will extend drying times and

could cause the safety cut-out to trip.

– Exhaust air must not be discharged into a flue which is

used for exhausting fumes from appliances burning gas or

other fuels.

– Under no circumstances should anything other than the

recommended articles be placed in the tumble dryer.

– The tumble dryer should be serviced by an appointed

service organisation and only genuine parts used.

– It is dangerous to alter or modify the product in any way

other than fitting authorised accessories.

–We recommend that the appliance is unplugged each time

after use. It should always be disconnected from the

electricity supply if it is to be left unattended for long

periods (i.e. weekends, holidays etc.)

– The rear of the dryer gets quite hot during use, position the

dryer so that the back is not accessible while in operation,

but the sides have a space available to allow air flow.

– It is important to clean fluff from the window of the dryer

and around the door seal after each drying cycle.Failure to

do so could result in water leaking.

– DO NOT use a two-way adaptor, or extension lead. The

dryer must be connected to its own socket.

– DO NOT block the air inlets at the back of your dryer.

– DO NOT allow fluff to accumulate around the tumble dryer.

– DO NOT exceed the recommended maximum load.

– DO NOT allow children to tamper with the controls and

keep them away from the dryer when it is in operation.

– DO NOT place articles in the dryer if anything other than a

water solution has been used in the cleaning process.

– DO NOT attempt to dry dripping wet articles or items

containing foam rubber or rubber-like materials.

– DO NOT use the tumble dryer if you suspect that it is

damaged in any way. Under no circumstances should you

attempt to repair the appliance yourself. Repairs carried

out by inexperienced persons may cause serious injury.

Consult your local appointed service engineer and insist

on only genuine spare parts.

THIS APPLIANCE MUST BE EARTHED

5. IMPORTANT USER INFORMATION

These notes are provided in the interest of safety.You must read them before installing or using the appliance.

Open the door. Undo screw (A) remove

switch strike (B) and replace screw, Remove

screws (C) and latch plate (D). Remove

hinge cover screw (E). Close the door.

Open the door. Undo screw (A) remove switch

strike (B) and replace screw, Remove screws (C)

and latch plate (D). Remove hinge block screw

(E). Remove door from hinge blocks.

Your dryer is fitted with a reversible door. To change the direction of opening proceed as follows for your type of door.

Dryers fitted with hinge cover :-

Pull the hinge cover (F) forwards to

remove it. Remove two outer

screws (G). Remove door. Fit latch

plate (D) with screws (C)

Remove hinge screws (F) and hinge (G)

and re fit to opposite side as shown.

Reverse door and fit to dryer in

closed position. Refit screws (G)

and hinge cover (F). Open the door.

Refit latch plate (D) with screws (C). Remove

screw (H) at top of door and re fit switch strike

(B) as shown. Fit door to hinge blocks and

secure with screws (E)

Fit screw (E) to secure hinge cover.

Remove screw (H) at top of door

and refit switch strike (B) as shown.

Dryers fitted without hinge cover :-

C D

6. ADDITIONAL INFORMATION

ANY PROBLEMS

If you feel the appliance is not drying correctly, please carry out

these quick checks:

– MIN.(SLOW) ENERGY SETTING

Please note that this setting is 4 times as long as the

MAX.(FAST) Setting and could be up/to 8 hours.

When using this setting, no heat can be felt from the

appliance.

– MAX.(FAST) SETTING

When using this setting, the machine and load may feel

cooler than a conventional tumble dryer. This is due to it’s

energy saving capabilities and is perfectly normal.

–Check that you used the correct heater setting (If

applicable).

– Check that the lint filter has been has been cleaned and the

vent hose is not constricted. A blocked filter or

vent hose will restrict the airflow.

– Check that your dryer is heating - below the door to the right

side, should feel warm to the touch after the first 10-15

minutes of its programme. Failure to heat may indicate the

safety cut-out has operated. To reset, simply press the red

button at the rear of the machine. If it has operated, a sharp

“click” will be heard. This cut-out only operates if the airflow

is severely restricted so make sure the filter is clean, the air

inlets and outlets at the front and back are not blocked, and

that all other restrictions are removed before re-starting.

– Check that the machine has the correct weight load in the

drum.

If the cut-out continues to operate after checking the above

points, you should contact your service agent.

If your machine does not work check the following before calling

a service engineer:

– Check that there is a supply of electricity.

– Check that the door has been properly closed and the

machine is switched on.

– Check the plug internal connections.

OPTIONAL EXTRAS

Vent Hose

Only available for fixed rear dryers. Leads the warm, damp air

to an open door or window.

Wall/Window Vent Kit

To make a permanent connection through a wall or window. Front

venting dryers need converting to rear venting before installing

this kit (see ‘Front to Extendible Rear Venting Kit’ above).

Stacking Kit

To enable your dryer to be secured onto the top of a front

loading washing machine (to save floor space).

The above items can be purchased as accessories for your

tumble dryer from your supplier.

FOR SERVICE IN THE UK

SERVICE FORCE: 08705 929 929

WHIRLPOOL: 0870 600 8989

OVERALL DIMENSIONS:

Height: 85 cm Width: 59.5 cm Depth: 53 cm

MAXIMUM DRY WEIGHT LOADS:

Cotton 5kg (for minimum creasing 2kg) Delicates 2kg

For electrical ratings see plate on back of dryer.

For Model No.see serial plate inside door (needed when requesting service).

Room temperature range 2

C to 25

Your washing machine should have a spin speed of not less than 800rpm.

Programme 2 was used in min.(slow) Energy mode’ to rate the energy efficiency of this dryer.

TECHNICAL DATA

This label, positioned on the rear of your dryer,

indicates the surface is hot when in operation -

avoid touching

CAUTION HOT SURFACE

11653 84424 GBBroadsheet23/2/04 23/2/04 2:29 pm Page 1

1 2

Inhaltsverzeichnis

Seite 1 - 6. ADDITIONAL INFORMATION

INSTRUCTIONS FOR USEIMPORTANT:PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE.KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.GB7

Seite 2 - 1. INSTALLATION

4. OPERATION2. THE CONTROLS3. PREPARATION1. INSTALLATIONTUMBLE DRYER VENTINGYour tumble dryer will release warm, damp air in one of theseways:A perman

Kommentare zu diesen Handbüchern

Keine Kommentare

Crosslee CL847W-031284715901 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wäschetrockner Crosslee CL847W-031284715901 herunter. Crosslee CL847W-031284715901 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern